Ce-niehoff-co C102/C102-1 Installation Uživatelský manuál stáhnout pdf (Strana 2)

C. E. Niehoff & Co. • 2021 Lee Street • Evanston, IL 60202 Tech Services Hotline 800-643-4633

II128A

Page 2 of 2

Use Fan & Pulley Assembly: A3-302

FAN AND PULLEY INFORMATION

Re-establishing magnetic ﬁ eld.

If no output is obtained - See Service Manual for speciﬁ c alternator test.

With engine running, disconnect plug between alternator and regulator and momentarily touch the male terminal (E1) from

the alternator plug to the negative output stud (E2) on the alternator (Figure E). Caution: Touching regulator terminal to

the negative output stud must be rapid to avoid possible alternator damage.

There are several conditions which may cause the alternator to loose its magnetic ﬁ eld. To re-establish the magnetic ﬁ eld, perform the

following procedure:

1. Review installation instructions step by step.

2. Check all wiring for clean and secure connections.

3. Excite ﬁ eld coil to re-establish magnetic ﬁ eld in rotor core. See instructions below for details.

4. If system still does not operate properly, connect ammeter and voltmeter to read alternator output. Set engine R.P.M. at 1500 to 2000.

Read amps and voltage and compare to chart.

If, after installation, the system does not meet speciﬁ cations:

TROUBLE SHOOTING

AMPS VOLTS

LOW OR 0

NORMAL

13.0 to 14.8

Charging system operating properly.

LOW OR 0

LOW

Less than 13.0

1. Check belt tension.

2. Bypass regulator. See figure C below.

HIGH

More than 14.8

1. Check regulator connections and grounds.

2. If voltage is still high, replace regulator.

HIGH

LOW

Less than 13.0

Discharged or defective battery.

Charge or replace battery.

SYSTEM SPECIFICATIONS

BRUSHLESS

ALTERNATOR

EXTERNAL

REGULATOR

MINIMUM

WIRE SIZE

(AWG)

VOLTS AMPS GROUND

MAXIMUM

RPM

REGULATOR

WEIGHT

(POUNDS)

STEPS

VOLTAGE

SETTINGS

A1-102 A2-102 6 12 60 N OR P 10,000 2 13.8 / 14.5 18

C102/C102-1

1 2

Komentáře k této Příručce

Žádné komentáře

Ce-niehoff-co C102/C102-1 Installation Uživatelský manuál Strana 2

Komentáře k této Příručce

Související produkty a manuály pro Hardware Ce-niehoff-co C102/C102-1 Installation